Cart
empty
All
Home / Catalog / Seals & Gaskets / Seals windshield and rear window

Seals windshield and rear window

Code
180-965
Condition
Reproduction
Availability
Available
For
ZAZ-965 Jalta
Producer
Modern production
Delivery terms
Can be delivered in any region at the expense of the buyer
Category
Section
1.500 - 8.400 rubles apiece
Below you can write a note for the basket

Windshield and rear window seals for ZAZ-965 "Zaporozhets" cars and their modifications. Modern production, material - rubber. The cost is per set. In stock:

  • Option No. 1 - 8,400 rubles per piece - one seal can be used on either the windshield or rear window. Glued to the required length.
  • Option No. 2 - 1,500 rubles apiece. Supplied as a 2.7 meter profile section. Can be used on both windshield and rear window. Before installation, the seal is put on along the perimeter of the glass with a slight interference and cut to length. Then it is shortened by an additional 10 mm. After fitting, the seal is removed from the glass, the joint is glued with super glue. Then the glass is installed in a standard way. The profile is made according to factory drawings and is fully consistent with the original.

The ZAZ-965 "Zaporozhets" windshield and rear windows are interchangeable, that is, the same, respectively, the windshield seal is no different from the rear window seal.

 

Уплотнители лобового и заднего стекла для автомобилей ЗАЗ-965 "Запорожец" и их модификаций. Современное производство, материал - резина. Стоимость приведена за комплект. В  наличии:

  • НЕТ В НАЛИЧИИ - Вариант №1 - 16800 рублей за комплект - Комплект состоит из двух уплотнителей, один на лобовое, другой на заднее стекло. Возможна поставка уплотнителей по одному, то есть только для лобового или только для заднего стекла. В этом случае стоимость одного уплотнителя составит 8000 рублей. 
  • Вариант №2 - 1500 рублей за штуку - Поставляется в виде отрезка профиля длиной 2,7 метра. Может быть использован как на ветровом, так и на заднем окне. Перед установкой уплотнитель надевается по периметру стекла с небольшим натягом и отрезается по длине. Затем укорачивается дополнительно ещё на 10мм. После подгонки уплотнитель снимается со стекла, стык склеивается супер-клеем. Далее установка стекла производится стандартным способом. Профиль выполнен по заводским чертежам и полностью соответствует оригиналу.
  • Вариант №1 - 8400 рублей за штуку - один уплотнитель может быть использован или на лобовое, или на заднее стекло. Склеен по нужной длине.

У ЗАЗ-965 "Запорожец" лобовое и заднее стекла взаимозаменяемы, то есть одинаковые, соответственно, уплотнитель лобового стекла ничем не отличается от уплотнителя заднего стекла.

Delivery to any country in the world
We send parcels to all countries in the world where the postal service.
The cost of each part does not include shipping costs.
Delivery
1 USD =
1 EUR =
100 KZT =
1 BYN =
92.59 rub
100.27 rub
20.57 rub
28.45 rub
All currency rates
How to make an order How to find the right parts
Our contacts
St. Petersburg
Kondratievsky Avenue Building 2, on the 2nd floor.
Mon-Fri: 10:00 - 19:00
Sat: 11:00 - 16:00
Su: off
Call local time
Now in St. Petersburg
Similar products
ZAZ-965 Jalta
1300 rubles per set
Available
Reproduction
Door seals around the perimeter
Door seals around the perimeter
ZAZ-965 Jalta
1500 - 9600 rubles per set
Available
Reproduction
Seals side (deaf) glass
Seals side (deaf) glass
Seals side (deaf) glass
Seals side (deaf) glass
Seals side (deaf) glass
6
photos
ZAZ-965 Jalta
1650 rubles per set
Available
Reproduction
Sealant doorways 965-6107094A1
Sealant doorways 965-6107094A1
Sealant doorways 965-6107094A1
ZAZ-965 Jalta
1600 - 2400 rubles per set
Available
Reproduction
Headlight housing gaskets 965-3712018-В
Headlight housing gaskets 965-3712018-В
Headlight housing gaskets 965-3712018-В
Headlight housing gaskets 965-3712018-В